#I hear echo when i use microphone on mixxx dj how to#

How to use a DJ mixer: Familiarizing Yourself Turn on your mixer, and then test everything is working and sound is coming in on the any of your channels.Adjust the amplifier’s volume to whatever level, frequency or pitch that you desire.Make sure the volume controls are set to low, so you don’t accidentally blast music unexpectedly (it made me jump like a cat last time I did that!).Once both the input and output jacks are connecting both the mixer and amplifier or speakers in their respective right and left slots, turn on the speaker or amplifier’s power cord.Connect your power lead but don’t turn the mixer on yet.After that, simply attach the other ends of the right and left jacks to their respective input jacks on your amplifiers.Attach the left and right outer jacks to their respective jack outputs on the back of the mixer.

Make sure the speakers’ cable is straightened to prevent any unwanted accidents, and make sure there are no excess wires near the speakers.

Place the speaker or amplifier in a suitable location in the room you prefer.

But to summarize the setup, follow these steps: If you’re using separate booth monitors use the booth outputs. The main active speakers will be connected to the master 1 or 2 outputs, you can also connect amplifiers here. How to Connect a DJ Mixer to Speakers or Amplifiers This will be connected to the signal GND/earth/ground connector on the mixer.

You will also find a ground or earth wire on the back of your turntables. So if you’re using vinyl decks do the same as above, but use the phono connections instead.

The phono connections are used to connect turntables.